Main Content
    Home >> News >>
IEC61347 Standard Lamps Power Supply
Add time:2014-12-01    Click:875
Our company's Desk Lamp power supply and Auxiliary lighting power supply is in strict accordance with IEC61347 standards, each test by IEC61347 standard, fully compliant with IEC61347 standard of quality lamps power supply.

New LED driver standard IEC 61347-2-13 
From the 1st July 2009 all LED drivers need to adhere to the IEC 61347-2-13 safety standard which specifies particular safety requirements for electronic control gear for use on d.c. supplies up to 250 V and a.c. supplies up to 1 000 V at 50 Hz or 60 Hz and at an output frequency which can deviate from the supply frequency, associated with LED modules.
 
There are many improved requirements that this new standards brings to LED drivers however the most noticeable one will be the change required in the output connectors that connect the driver to the LED fixture. The majority of LED drivers use the RJ45 connector originally designed as network card connector in PC’s and these will need to be changed to double insulated type connectors if the maximum output voltage for a constant current driver is greater than 25Vdc.
 
IEC 61347 consists of the following parts, under the general title Lamp controlgear: 
Part 1: General and safety requirements 
Part 2-1: Particular requirements for starting devices (other than glow starters) 
Part 2-2: Particular requirements for d.c. or a.c. supplied electronic step-down convertors 
for filament lamps 
Part 2-3: Particular requirements for a.c. supplied electronic ballasts for fluorescent lamps 
Part 2-4: Particular requirements for d.c. supplied electronic ballasts for general lighting 
Part 2-5: Particular requirements for d.c. supplied electronic ballasts for public transport 
lighting 
Part 2-6: Particular requirements for d.c. supplied electronic ballasts for aircraft lighting 
Part 2-7: Particular requirements for d.c. supplied electronic ballasts for emergency lighting 
Part 2-8: Particular requirements for ballasts for fluorescent lamps 
Part 2-9: Particular requirements for ballasts for discharge lamps (excluding fluorescent 
lamps) 
Part 2-10: Particular requirements for electronic invertors and convertors for high-frequency 
operation of cold start tubular discharge lamps (neon tubes) 
Part 2-11: Particular requirements for miscellaneous electronic circuits used with luminaires 
Part 2-12: Particular requirements for d.c. or a.c. supplied electronic ballasts for discharge 
lamps (excluding fluorescent lamps) 
Part 2-13: Particular requirements for d.c. or a.c. supplied electronic controlgear for LED 
modules

诚信网站